No, after a factory reset, the password on the device remains activated.
For end-customers, the device password should be in the documentation provided by the electrical engineering firm. If this is not the case, please contact your specialist installer as the device is built-in and therefore you cannot access it.
If you have updated the firmware of the device for which you have not yet received a password, the new password after the firmware update will be “device”.
Up to 50 scene sets can be created in the Gira X1.
Each scene can then be triggered by up to ten trigger points.
A factory reset can be performed on the device on-site. Following this, the device password affixed to the device is reactivated.
Perform a factory reset as follows:
Whilst the wired KNX system exchanges information via a KNX cable, the KNX RF system uses a wireless signal, meaning there is no need to lay cables. KNX RF can also be used to extend an existing wired KNX system.
Yes, the Gira X1 has a KNX interface function so that you can launch ETS projects remotely, for example.
Send us an E-mail. We will reply to you in writing as soon as possible.
We would be happy to advise you.
Monday to Thursday 9:00am – 5:00 pm Friday 9:00 am – 12:00pm